Focusrite Scarlett 2i2 4th gen vs Universal Audio Volt 2

Both are audio interfaces, $199 against $199. This page puts them side by side on the only three things a maker can be held to — power, output impedance and noise — and then asks the question that actually matters: which headphones do they treat differently?

The Universal Audio Volt 2 reaches 100 dB on 558 of the 567 models here, the Focusrite Scarlett 2i2 4th gen on 552.

A figure marked not published is missing from the maker’s own material, which is not the same as being good or bad. Where one of these two publishes a number and the other does not, the comparison on that axis cannot be made at all — and saying so is more useful than guessing.

Both makers publish a power rating, which is less common than the table above makes it look: of the 280 sources here, 209 publish a figure at at least one load and only 2 publish one at all four. Focusrite Scarlett 2i2 4th gen publishes at 300 Ω; Universal Audio Volt 2 at 32 Ω, at 300 Ω and at 600 Ω. Every other row is worked out from those — between two published loads, or beyond them holding voltage constant, which understates rather than flatters.

So the two columns are not equally firm row by row: at 32 Ω and at 600 Ω only the Universal Audio Volt 2 figure is the maker’s own. On those rows the derived number is the one to doubt first.

What each of these labels means, and why a derived figure is still worth printing, is set out in how this data was built.

6 headphones reach 100 dB on the Universal Audio Volt 2 but not on the Focusrite Scarlett 2i2 4th gen — HiFiMAN HE-6se V2, HiFiMAN HE6 Remastered, HiFiMAN Susvara, 3 more.

552 of the 567 models here reach 100 dB on both. That is a power count and nothing more; whether either source suits a given headphone also depends on the two lines above.

The counts above say how many models the two treat differently. This says by how much. The same 8 headphones appear on every page of this kind, ordered from the easiest to drive to the hardest, so a row can be read across pages as well as across columns. Headroom is at a 100 dB SPL peak.

The widest gap on the list is the HiFiMAN HE400se: Universal Audio Volt 2 has +9 dB of headroom there against +5 dB. 4 dB is about 2.7 times the power, which matters for peaks rather than for how loud the music sits.

The hiss columns are empty for Focusrite Scarlett 2i2 4th gen and Universal Audio Volt 2 because neither maker publishes no output noise figure. That is a gap in the specification, not a quiet amplifier, and it is left blank here rather than filled with a plausible number.

These two cost the same, $199, so price settles nothing. Out of the 567 models here, the Universal Audio Volt 2 drives 6 models to 100 dB — and on the other side there is no such advantage at all.

Everything in this paragraph counts only figures the two makers published. An advantage on an axis one of them leaves blank cannot be counted, and is not counted — how often that happens is its own page.

Each has a page of its own with every power figure traced to what the maker published and a full headphone list: Focusrite Scarlett 2i2 4th gen and Universal Audio Volt 2. Or put either against your own headphones in the source comparison tool.