The Simgot EA500LM is 21Ω at 106.2 dB/mW; the Simgot EW200 is 16Ω at 108.0 dB/mW. This page is only about what they ask of an amplifier — not how they sound, which no specification on either sheet can tell you.
The EA500LM needs 1.8 dB more than the EW200 to reach the same loudness — 0.24 mW against 0.16 mW.
| Specification | EA500LM | EW200 |
|---|---|---|
| Impedance | 21 Ω | 16 Ω |
| Sensitivity | 106.2 dB/mW | 108.0 dB/mW |
| Sensitivity (voltage) | 123.0 dB/V | 126.0 dB/V |
| Power for 100 dB | 0.24 mW | 0.16 mW |
| Voltage for 100 dB | 71 mV | 50 mV |
| Current for 100 dB | 3.4 mA | 3.1 mA |
| Highest source impedance that leaves them alone (one-eighth rule) | 2.62 Ω | 2.00 Ω |
| Sources that reach 100 dB out of 280 | 280 | 280 |
Every source in the database that drives one of them drives the other. On power, the choice between these two changes nothing about what amplifier you need.
11 sources stay below the audible-hiss threshold with the EA500LM but cross it with the EW200 (Lake People G103-S Mk II, Schiit Valhalla 3, Lake People G111 Mk II, 8 more).
280 of the 280 sources here reach 100 dB on both. That count is about power only — the output-impedance and hiss lines above are separate questions, and a source can pass this one and fail those.
The gap between these two in decibels does not change with volume — it is a property of the two headphones. What changes is the size of the numbers, and it changes fast: every 10 dB costs ten times the power. The row that matters is the one nearest the level you listen at, and for most people that is nearer the top of this table than the bottom.
The EA500LM is more demanding than 22% of the 567 non-electrostatic models in this database; the EW200 than 11%. Both figures use the same measure as the rest of the site: whichever runs out first against a 2 V, 100 mW dongle, voltage or power.
| dB SPL | EA500LM power | EA500LM voltage | EW200 power | EW200 voltage |
|---|---|---|---|---|
| 80 | 2.4 µW | 7 mV | 1.6 µW | 5 mV |
| 85 | 7.6 µW | 13 mV | 5.0 µW | 9 mV |
| 90 | 0.02 mW | 22 mV | 0.02 mW | 16 mV |
| 95 | 0.08 mW | 40 mV | 0.05 mW | 28 mV |
| 100 | 0.24 mW | 71 mV | 0.16 mW | 50 mV |
| 105 | 0.76 mW | 0.13 V | 0.50 mW | 90 mV |
105 dB is included because forum power figures are usually quoted there or higher. It is also a level that damages hearing in minutes — how many minutes is its own calculator.
| Source | Price | Headroom, EA500LM | Headroom, EW200 | Output impedance | Noise |
|---|---|---|---|---|---|
| JadeAudio JA11 | $20 | 19.1 dB | 19.8 dB | 0.5 Ω | 1.7 µV |
| FiiO KA11 | $29 | 29.6 dB | 31.9 dB | 0.7 Ω | 1.7 µV |
| FiiO BTR13 | $59 | 26.6 dB | 28.8 dB | 0.6 Ω | 1.0 µV |
Of the 280 sources here, 280 reach 100 dB on both. That is the easy axis. 57 of them also publish an output impedance low enough for both under the one-eighth rule and a noise figure that stays below the audible-hiss threshold with both — the rest either fail one of those or never printed the number at all, and 208 of them are in the second group.
The cheapest of the 57 is the JadeAudio JA11, at $20. It leaves 19.1 dB of headroom on the EA500LM and 19.8 dB on the EW200, its output impedance is 0.5 Ω against a one-eighth limit of 2.62 Ω and 2.00 Ω, and its noise figure puts the hiss floor 12 dB and 9 dB below the 20 dB SPL this site treats as the point where a quiet room stops hiding it.
Cheapest that satisfies three published numbers is not the same as best, and none of it is about how either headphone sounds. To put either model against a source this page does not mention, or to change the target loudness, use the amplifier matcher.
Each model has a page of its own with the full source list, the hiss estimate and the provenance of every figure above: Simgot EA500LM and Simgot EW200. Each figure on this page is labelled on those pages with where it came from, including the ones Simgot never published — what that maker publishes, counted.