Will an audio interface drive the HiFiMAN Sundara?

On power, yes — all of them. Every one of the 65 audio interfaces in this database reaches 100 dB SPL on the HiFiMAN Sundara, which needs 6.3 mW at its 32Ω.

Power is one of three questions and the one that goes wrong least often. The other two — whether the source’s output impedance leaves the frequency response alone, and whether you will hear its noise floor — are answered further down, separately, because a source can pass one and fail another.

The cheapest one that does reach it is the Zoom AMS-22 at $100, which delivers 20 mW into 32Ω — 5 dB of headroom over the 6.3 mW this headphone needs for 100 dB SPL.

100 dB SPL is a peak level, not a listening level. If you listen at 85 dB the same headphone needs 0.20 mW, which is 15 dB less, and the answer above changes for most of the category. The model page has the full ladder.

Under the one-eighth rule the HiFiMAN Sundara wants a source below 4.00Ω. Of the 43 audio interfaces here that publish an output impedance, 15 are under it and 28 are not.

The furthest over is the Tascam US-2x2HR at 66Ω, which is 16× the ceiling. Above that threshold the source stops being a volume control and starts being part of the frequency response. The simulator shows what that looks like.

The other 22 publish nothing at all on this, so they are not on either side of that count. This site leaves them blank rather than assuming a figure.

Hiss depends on the source’s own noise floor and on how sensitive the headphone is. At 92.0 dB and 32Ω, the HiFiMAN Sundara turns one microvolt of source noise into about -13 dB SPL — and the threshold where that stops being noticeable in a quiet room is around 20 dB SPL.

Of the 4 audio interfaces here that publish a noise figure, 4 stay below that threshold with this headphone and 0 cross it.

The remaining 61 publish no noise figure, so they cannot be placed on either side.

4 of the 65 audio interfaces here publish all three figures. 3 of those clear all three for the HiFiMAN Sundara, and the cheapest is the RME ADI-2 DAC FS at $1399.

It delivers 1.2 W into 32 Ω where this headphone needs 6.3 mW for 100 dB — 22.8 dB of headroom — its output impedance of 0.1 Ω sits under the one-eighth ceiling of 4.00 Ω, and its 2.18 µV of noise leaves the hiss 26 dB under the 20 dB SPL threshold this site uses.

Cheapest that satisfies three published numbers is not the same as best, and the sources left out of this count are left out for want of a published figure, not for failing one. How often that happens is its own page.

Sorted by how many of the three questions the source answers well, then by price. A blank in a column is a blank in the manufacturer’s own documentation, not a zero.

The HiFiMAN Sundara on other categories: portable players · desktop amplifiers · desktop DAC/amps.

The HiFiMAN Sundara page has every source in the database against this headphone, and the matcher takes your own numbers.